Wheel wells painted a grey green and enclosing pieces held in place with drafting tape so the glue could dry. Intake tubes (left) need to fit in horiz. slot so lots of sanding had to be done to get it to fit on a test run.
Cockpit glass in place. Again lots of sanding done to back section of main glass. It still doesn't fit perfect but all in all better than it was. Details show through nice.
Opposite side angle shot of wheel wells with tape removed. We shall see.
Rear brake flaps drying. I think I'm going to set them in the open position. Also intake tubes with opening flaps in place.
Finally, the current state of the workbench...
No comments:
Post a Comment